Under Control Panel - Settings - Power management, I was able to see it was charging and had good voltage.
TRIMBLE SURVEY CONTROLLER ACU SOFTWARE
Controller software, and processing software products that are designed to works together for Real- Time Kinematic surveying. Trimble controllers (TSCe or ACU) running the Trimble Survey.
It applies to version 10.0 of the Trimble Survey Controller software. Release Notice This is the July 2001 release (Revision A) of the Survey Controller User Guide, part number 44011-00-ENG. I used the back side of an exact-o-knife to tuck the wires into the case before closing the case completely.ĭid it power up? Yup. In this course, you will learn about and use Trimble receivers, the. patents cover the Trimble Survey Controller software: 6021376, 6016118, 5986604, 5969708, 5831573, 5614913 and other patents pending. Patience is required to get things to line up. When I first opened this case, I noticed that one of the battery wires was pinched in-between the case seal. However it has been weakened from shaving the case. I think this is what the post is there to prevent. This would probably compromise the water seal. This pressure is enough that I did not have to use any foam spacers to keep the battery from sliding around.īe careful that you remove enough material from the case, otherwise the battery will bow the edge of the case when you tighten the case screws. This reduces the height enough to get the case to close, while still exerting slight pressure on the battery. To the right, you can see the rotary file that I used to contour the case, enabling the battery to rock over further towards the edge of the case. Here you can see how the battery pack is positioned in the case. I had to remove some of the foam tape, as well as shave some of the internal case in order to get the battery pack to fit properly. Presumably the OEM cells were staggered to make them a little smaller because the replacement battery pack was just a little too big to have the case close without putting undue pressure on the upper circuit board (pictured in the far left of the third photo). In order to gain access to the battery compartment, you can hinge the case apart without taking any other cabled off. The OEM battery pack is packaged with the cells slightly staggered, while the replacement battery pack is packed flush at the ends. So the numbers really don't mean much other than to state the voltage and capacity.
TRIMBLE SURVEY CONTROLLER ACU PLUS
Batteries Plus took the sticker off the old OEM battery pack and transferred it to the new one. It was made using four 1.2 volt, 1000mAh 5/3AAA NMH cells, connected in series to achieve a nominal voltage of 4.8 volts. The arrows point to the power plug and two points where the OEM pack contacted the case. There are no clips, it is a friction connection. I only opened the case as far as I needed to gently pry the power connection apart (using the tip of a exact-o-blade). Here is a picture showing what it looked like after I took all of the screws out of the back. An update, I finally got my replacement battery pack and finished putting things together.
0 kommentar(er)
